Physics Journal

Articles Information

Two and Three Dimensional Investigation of Bubble Rising in High Density Ratio

Pages: 1-9 Views: 1577 Downloads: 1385

[01]
Elham Sattari, Department of Mechanical Engineering, Babol Noushirvani University of Technology, Babol, Iran.
[02]
Mojtaba Aghajani Delavar, Department of Mechanical Engineering, Babol Noushirvani University of Technology, Babol, Iran.
[03]
Ehsan Fattahi, Department of Numerical Mathematics, Technical University of Munich, Munich, Germany.
[04]
Korosh Sedighi, Department of Mechanical Engineering, Babol Noushirvani University of Technology, Babol, Iran.

In present paper three-dimensional isothermal Lattice Boltzmann Method have been used to simulate the motion of bubble. The above model is unified with another two dimensional non-isothermal model in order to reduce computational cost. Firstly, it is ensured that the surface tension effect and Laplace law are properly implemented. Secondly, effect of governing dimensionless numbers on terminal Reynolds number and terminal shape of bubble are investigated in 3D and 2D simulations. Different flow patterns in various dimensionless numbers are obtained and by changing the dimensionless number, terminal change of bubble’s shape are seen. The error of 2D solution is calculated. The results show that with increasing terminal Reynolds number increase the difference between 2D and 3D solutions and in high Reynolds number, 2D simulation for this phenomenon is not acceptable.

Two Phase Flow, Lattice Boltzmann Method, Free Energy Approach

[01]
A.K. Gunstensen, D.H. Rothman, S. Zaleski, G. Zanetti, Lattice Boltzmann model of immiscible fluids. Physical Review A, 1991. 43(8): p. 4320.
[02]
X. Shan, H. Chen, Lattice Boltzmann model for simulating flows with multiple phases and components. Physical Review E, 1993. 47(3): p. 1815.
[03]
M.R. Swift, W. Osborn, J. Yeomans, Lattice Boltzmann simulation of nonideal fluids. Physical Review Letters, 1995. 75(5): p. 830.
[04]
T. Inamuro, T. Ogata, F. Ogino, Numerical simulation of bubble flows by the lattice Boltzmann method. Future Generation Computer Systems, 2004. 20(6): p. 959-964.
[05]
T. Inamuro, T. Ogata, S. Tajima, N. Konishi, A lattice Boltzmann method for incompressible two-phase flows with large density differences. Journal of Computational Physics, 2004. 198(2): p. 628-644.
[06]
T. Inamuro, S. Tajima, F. Ogino, Lattice Boltzmann simulation of droplet collision dynamics. International journal of heat and mass transfer, 2004. 47(21): p. 4649-4657.
[07]
B. Sakakibara, T. Inamuro, Lattice Boltzmann simulation of collision dynamics of two unequal-size droplets. International journal of heat and mass transfer, 2008. 51(11): p. 3207-3216.
[08]
T. Inamuro, Lattice boltzmann methods for viscouse fluid flows and two-phase fluid flows, in Computational Fluid Dynamics. 2008, Springer: India. p. 3-16.
[09]
Y.Y. Yan, Y.Q. Zu, LBM simulation of interfacial behaviour of bubbles flow at low Reynolds number in a square microchannel in COMPUTATIONAL METHODS IN MULTIPHASE FLOW V. 2009. New Forest: WIT Press.
[10]
M. Yoshino, Y. Mizutani, Lattice Boltzmann simulation of liquid–gas flows through solid bodies in a square duct. Mathematics and computers in simulation, 2006. 72(2): p. 264-269.
[11]
Y. Yan, Y. Zu, A lattice Boltzmann method for incompressible two-phase flows on partial wetting surface with large density ratio. Journal of Computational Physics, 2007. 227(1): p. 763-775.
[12]
Y.Y. Yan, Y.Q. Zu, Numerical modelling of bubble coalescence and droplet separation, in COMPUTATIONAL METHODS IN MULTIPHASE FLOW IV. 2007, WIT Press: Bologna, Italy. p. 227-237.
[13]
Y. Tanaka, Y. Washio, M. Yoshino, T. Hirata, Numerical simulation of dynamic behavior of droplet on solid surface by the two-phase lattice Boltzmann method. Computers & Fluids, 2011. 40(1): p. 68-78.
[14]
Y. Tanaka, M. Yoshino, T. Hirata, Lattice Boltzmann simulation of nucleate pool boiling in saturated liquid. Communications in Computational Physics, 2011. 5.
[15]
T. Lee, Effects of incompressibility on the elimination of parasitic currents in the lattice Boltzmann equation method for binary fluids. Computers & Mathematics with Applications, 2009. 58(5): p. 987-994.
[16]
T. Lee and C.-L. Lin, A stable discretization of the lattice Boltzmann equation for simulation of incompressible two-phase flows at high density ratio. Journal of Computational Physics, 2005. 206(1): p. 16-47.
[17]
T. Lee and L. Liu, Lattice Boltzmann simulations of micron-scale drop impact on dry surfaces. Journal of Computational Physics, 2010. 229(20): p. 8045-8063.
[18]
H. Zheng, C. Shu and Y.-T. Chew, A lattice Boltzmann model for multiphase flows with large density ratio. Journal of Computational Physics, 2006. 218(1): p. 353-371.
[19]
S. E. Mousavi Tilehboni, K. Sedighi, M. Farhadi, E. Fttahi, Lattice Boltzmann Simulation of Deformation and Breakup of a Droplet under Gravity Force Using Interparticle Potential Model. International Journal of Engineering-Transactions A: Basics, 2013. 26(7): p. 781.
[20]
T. Seta and K. Okui, Effects of truncation error of derivative approximation for two-phase lattice Boltzmann method. Journal of Fluid Science and Technology, 2007. 2(1): p. 139-151.

Vol. 5, Issue 1, March Submit a Manuscript Join Editorial Board Join Reviewer Team

About This Journal |

All Issues |

Open Access |

Indexing |

Payment Information |

Author Guidelines |

Review Process |

Publication Ethics |

Editorial Board |

Peer Reviewers |

Copyright © 2014 - American Institute of Science except certain content provided by third parties.